Chery T21 2014 Service Manual page 1321

Steering Tie Rod Assembly
Removal
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove engine trim cover assembly
2. Remove air filter assembly
3. Remove front wheel (See page
4. Remove ball pin assembly
5. Remove steering tie rod assembly.
a. Remove steering tie rod boot clamp (2).
b. Remove steering tie rod boot clamping ring (1) and
remove steering tie rod boot.
CAUTION
 Operate carefully to prevent damage to the boot.
 It is necessary to replace with new clamping ring when reinstall the tie rod boot.
c. Using a wrench, remove steering tie rod assembly
(arrow).
Inspection
1. Check tie rod dust boot for damage and clamp for normal conditions. Replace the tie rod boot and clamp if
necessary to prevent water and micro dust from entering and causing parts failure prematurely.
2. Check tie rod for deformation or wear and ball for insufficient lubrication. Replace tie rod assembly or add
grease if necessary.
Chery Automobile Co., Ltd.
(See page 10-10).
(See page 10-17).
24-9).
(See page 30-22).
30 - ELECTRONIC POWER STEERING
1
2
30
RT21300170
RT21300171
23
30–