Chery T21 2014 Service Manual page 739

4
Confirm DTCs
a. Connect related wire harness connectors.
b. Connect the negative battery cable.
c. Turn ignition switch ON.
d. Connect X-431 3G diagnostic tester to Data Link Connector (DLC) to check if any DTC is detected.
System operates normally
OK
5
Reconfirm DTCs after replacing ABS module
a. Remove the ABS module
b. Replace the ABS module.
c. Connect X-431 3G diagnostic tester to Data Link Connector (DLC) again to check if any DTC is detected.
Repair or replace PEPS controller
NG
System operates normally
Chery Automobile Co., Ltd.
(See page 25-71).
15 - SQR484F STARTING SYSTEM
NG
OK
15–
15
55