ON-VEHICLE SERVICE
Activated Charcoal Canister Solenoid Valve and Bracket
Removal
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
Before removal, mark fuel vapor pipe III assembly and outlet hose to avoid confusion.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly
4. Remove the activated charcoal canister solenoid valve.
a. Disconnect the canister solenoid valve connector
(arrow).
b. Disengage the clamps (1) and disconnect both ends
of canister solenoid valve from the hose.
CAUTION
Positioning distance from hose end to clamp is 3 - 5 mm.
c. Remove the canister solenoid valve from the bracket.
5. Remove the activated charcoal canister solenoid valve bracket.
a. Remove 2 fixing bolts (arrow) from the activated
charcoal canister solenoid valve bracket, and remove
the activated charcoal canister solenoid valve bracket.
(Tightening torque: 7 ± 1 N·m)
Chery Automobile Co., Ltd.
09 - SQR484F EMISSION CONTROL SYSTEM
(See page
10-10).
1
RT21090030
RT21090040
09–
09
7