Chery T21 2014 Service Manual page 1020

22 - AXLE
Front Steering Knuckle
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents.
 Check if safety lock of lifter is locked when repairing chassis parts.
 It is not permitted to weld or modify bearing parts of wheel suspension and guide parts of wheel.
 When removing chassis parts, replace the self-locking nuts and rusted nuts for safety.
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove the front left wheel
2. Remove the front drive shaft assembly locking nut
3. Remove the front left brake caliper assembly
CAUTION
 Place front brake caliper assembly to a proper position after removal. Be careful not to extend front brake
hose excessively.
4. Remove the front left brake disc
5. Remove the front left hub assembly
6. Remove the front left mudguard
7. Remove the front left steering knuckle assembly.
a. Remove the coupling bolt (arrow) between front left
wheel speed sensor and front left steering knuckle
assembly, and disengage the front left wheel speed
sensor carefully.
(Tightening torque: 10 ± 1 N·m)
b. Remove the locking nut (arrow) between left steering
22
tie rod assembly ball pin and front left steering knuckle
assembly.
(Tightening torque: 47 ± 3 N·m)
12
22–
(See page 24-9).
(See page
(See page
(See page 26-28).
(See page 22-9).
(See page 22-9).
22-9).
26-28).
Chery Automobile Co., Ltd.
RT21220110
RT21220120