Chery T21 2014 Service Manual page 1137

g. Connect the negative battery cable.
h. Turn ignition switch ON.
i. Using a digital multimeter, measure the voltage between
connector E-085 and body ground to check if the front
right wheel speed sensor is short to power supply
according to the table below.
Standard Voltage
Multimeter
Condition
Connection
E-085 (4) - Body
Ignition switch ON Approximately 0 V
ground
E-085 (16) - Body
Ignition switch ON Approximately 0 V
ground
Repair or replace wire harness and
NG
connector between front right wheel
speed sensor and ABS control module
assembly
6
Reconfirm DTCs
a. Use X-431 3G diagnostic tester to clear the DTC.
b. Start the engine.
c. Drive the vehicle at 15 km/h or more, read the ABS control module assembly DTC again with X-431 3G
diagnostic tester.
d. Check if the same DTC is output.
System operates normally
NO
Replace ABS control module assembly
Chery Automobile Co., Ltd.
V
+ -
Specified
Condition
25 - BRAKE CONTROL SYSTEM
12 11 10 9 8 7 6 5 4 3 2
13
24 23 22 21 20 19 18 17 16 15 14
38
37 36 35 34 33 32 31 30 29 28 27 26
E-085
1
25
RT21250280
OK
YES
25
41
25–