Chery T21 2014 Service Manual page 1281

Bleeding Procedures
It is necessary to perform the bleeding procedures when bubbles occur in steering fluid reservoir assembly
and fluid has emulsified or there is excessive noise in power steering pump assembly.
Bleeding procedures are as follows:
1. Open the steering fluid reservoir cap.
2. Raise vehicle with a lifter (with front wheels off ground).
3. Start engine (idling) and turn steering wheel left and right to the limit positions (do not stay at the limit
positions more than 2 seconds). Repeat several times to fully bleed air in system from the reservoir.
Observe the fluid level of fluid reservoir during bleeding. If fluid level drops below "MIN" mark, add steering
fluid to proper level in time.
4. After repeatedly turning the steering wheel to the limit positions several times, center the steering wheel,
run engine at idle for 3 or 5 minutes and observe whether there are still bubbles in fluid reservoir. If there
are still bubbles, perform above procedures again until no bubbles are bled. If there are still problems,
perform steering system inspection.
Chery Automobile Co., Ltd.
29 - HYDRAULIC ASSIST STEERING
29
9
29–