26 - BRAKE
Inspection
1. Check brake light switch assembly.
a. Using ohm band of digital multimeter, check for
continuity between brake light switch assembly
terminals according to the table below.
Standard Condition
Multimeter
Connection
Terminal 1 -
Terminal 3
Terminal 2 -
Terminal 4
Terminal 1 -
Terminal 3
Terminal 2 -
Terminal 4
If result is not as specified, replace brake light switch
assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to tighten fixing nuts to the specified torque during installation.
Check that brake light operates properly after completing installation.
26
26
26–
Switch
Specified
Condition
Condition
Brake pedal
depressed (switch
Continuity
pin released)
Brake pedal
depressed (switch
No continuity
pin released)
Brake pedal
released (switch
No continuity
pin pushed)
Brake pedal
released (switch
Continuity
pin pushed)
+
-
Chery Automobile Co., Ltd.
1
2
3
4
RT21260300