Chery T21 2014 Service Manual page 1452

32 - SUPPLEMENTAL RESTRAINT SYSTEM
3
Check SRS warning light
4
Check for DTCs (current DTC and history DTC)
DTC
For current DTC, go to step 5
occurs
No 
32
For history DTC, go to step 6
DTC
5
Diagnostic Trouble Code (DTC) chart
6
Circuit inspection
HINT:
An activation prevention mechanism is built in the airbag system connector. When the connector is
disconnected, this mechanism cuts off the circuit by bringing the short spring plate into contact with the
terminals, thus insulating the circuit from external power sources to prevent accidental airbag activation.
To release the activation prevention mechanism, insert a piece of paper with the same thickness as the male
terminal between terminals and short spring plate to disconnect the connection.
WARNING
 DO NOT release the activation prevention mechanism unless specially directed by the troubleshooting
procedure.
During circuit troubleshooting for the airbag system, make sure to cut off the battery power source, and wait
for at least 90 seconds to discharge the system condenser.
When performing electrical diagnosis and test, always refer to the relevant circuit diagram for the special
circuit and component information.
7
Repair
12
32–
Chery Automobile Co., Ltd.
NEXT
NEXT
NEXT
NEXT