Chery T21 2014 Service Manual page 464

07 - SQR484F ENGINE MECHANICAL
Flywheel
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents when repairing.
 Try to prevent body paint surface from being scratched during removal and installation.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the transmission assembly
4. Remove the clutch assembly
5. Remove the flywheel.
07
a. As shown in the illustration, install the flywheel holding
tool (1) to hold the flywheel securely.
b. Remove 6 fixing bolts (arrow) from flywheel, and
remove the flywheel.
(Tightening torque: 1st step: tighten to 35 ± 5 N·m;
2nd step: retighten by 45° ± 5°)
WARNING
 Pay special attention to safety during operation, do not remove all flywheel fixing bolts without any
auxiliary measures.
 If necessary, other operators will be required to assist.
CAUTION
 Flywheel fixing bolts must be disposed after removal. Never reuse them.
Inspection
1. Check if crankshaft position signal gear is distorted or deformed. If damaged, replace the flywheel. Clean
the signal gear before installation.
2. Check if starter drive gear ring is worn. If excessively worn, replace the flywheel.
3. Check contact surface of clutch lining. If the contact surface is damaged or excessively worn, replace the
flywheel with a new one.
42
07–
(See page 17-21 for MT model,
(See page 19-14).
See page 18-130 for CVT model).
Chery Automobile Co., Ltd.
1
RT21070290