Chery T21 2014 Service Manual page 1121

5
Check wire harness and connector (ABS control module assembly - body ground)
a. Turn ignition switch to LOCK.
b. Disconnect the negative battery cable.
c. Disconnect the ABS control module assembly connector
E-085.
d. Using a digital multimeter, check for continuity between
ABS control module assembly terminal 13, 38 and body
ground to check if the system ground circuit is normal
according to the table below.
Standard Condition
Multimeter
Condition
Connection
E-085 (13) - Body
ground
E-085 (38) - Body
ground
Repair or replace engine compartment
NG
wire harness and connector
6
Reconfirm DTCs
a. Use X-431 3G diagnostic tester to clear the DTC.
b. Start the engine.
c. Drive the vehicle at 15 km/h or more, read the ABS control module assembly DTC again with X-431 3G
diagnostic tester.
d. Check if the same DTC is output.
System operates normally
NO
Replace ABS control module assembly
Chery Automobile Co., Ltd.
Specified
Condition
Always Continuity
Always Continuity
25 - BRAKE CONTROL SYSTEM
+ -
12 11 10 9 8 7 6 5 4 3 2
13
24 23 22 21 20 19 18 17 16 15 14
38
37 36 35 34 33 32 31 30 29 28 27 26
E-085
OK
1
25
RT21250210
OK
YES
25
25
25–