Chery T21 2014 Service Manual page 1093

Wheel
Removal
1. Remove the wheel.
a. Stop the vehicle at a level ground and apply parking brake.
b. Using a tire wrench, loosen the wheel mounting bolts.
c. Firmly support and raise vehicle to a proper height.
d. Using a tire wrench, remove 5 wheel mounting bolts.
e. Remove the wheel.
Installation
1. Install the wheel.
a. Anticorrosion treatment is conducted on the contact surface between wheel and brake disc.
b. Install the wheel and pre-tighten the wheel mounting bolts by hand.
c. Using a torque wrench, tighten the wheel mounting
bolts evenly to the specified torque in the order shown
in the illustration.
(Tightening torque: 110 ± 10 N·m)
CAUTION
 DO NOT attempt to repair wheels by striking, heating or welding.
 Replace wheel mounting bolts with the special wheel mounting bolts, rather than those with different
specifications or inferior quality.
 Be careful not to damage coating on wheel.
 To avoid damage to tire or over/under tightening the wheel mounting bolts, never use an impact wrench.
 DO NOT apply grease to wheel mounting bolts.
 To ensure wheel mounting bolts are tightened in place, wheel mounting nuts should be tightened after
driving 100 km at the first time.
Chery Automobile Co., Ltd.
24 - TIRE AND WHEEL
RT21240060
1
3
4
5
2
RT21240070
24–
24
9