Chery T21 2014 Service Manual page 587

Cleaning Process
1. Remove throttle body, and make the valve plate face
upward in free condition. Avoid cleaner flowing into
electronic element through valve plate shaft, resulting in
functional failure.
2. Start to clean when it is as shown in the illustration.
WARNING
 Cleaner is a kind of flammable and corrosive fluid. Follow safety cautions to prevent accidents, and avoid
skin contacting with the cleaner.
3. Apply appropriate amount of cleaner to the inner wall of throttle valve body, and remove the carbon with a
clean cloth.
4. Support the throttle valve plate with thin stick, and clean
the carbon on valve plate and throttle valve body inner
wall.
5. Turn over the throttle 180°, and perform cleaning with the same procedures as above. Repeat several
times until it is clean.
6. Push the valve plate by hand, and check if valve plate rotates smoothly. If it is stuck, clean the valve plate
again following the cleaning procedures.
7. After cleaning, wipe off cleaner in throttle valve body with absorbent paper.
Installation
Installation is in the reverse order of removal.
CAUTION
 Clean fitting surface of electronic throttle assembly.
 Perform throttle self-learning procedures after installation
start vehicle and observe if it operates properly.
 Check and add engine coolant.
Chery Automobile Co., Ltd.
10 - SQR484F INTAKE SYSTEM
(See page 06-19). After self-learning completed,
RT21100220
10
RT21100221
23
10–