Chery T21 2014 Service Manual page 1163

DTC Code DTC Definitions
C1001-04 ECU
ECU Hardware
C1009-00
Related
CAUTION
 When performing electrical equipment diagnosis and test, always refer to the circuit diagram for related
circuit and component information.
Diagnosis Procedure
1
Check ABS fuse
a. Turn ignition switch to LOCK.
b. Disconnect the negative battery cable.
c. Remove the ABS fuse EF-36 (10 A) from the engine compartment fuse and relay box.
d. Check if the fuse is blown.
Replace ABS fuse
NG
2
Check ABS control module assembly wire harness and connector
a. Turn ignition switch to LOCK.
b. Disconnect the negative battery cable.
c. Disconnect the ABS control module assembly connector E-085.
d. Check if the wire harnesses are worn, pierced, pinched or partially broken.
e. Look for broken, bent, protruded or corroded terminals.
f. Check if related connector pins are in good condition.
Repair or replace ABS control module
NG
assembly wire harness and connector
Chery Automobile Co., Ltd.
DTC Detection
Conditions
These DTCs occur
when any of the
following conditions is
met:
 Fuse malfunction
1. ABS control module
 Wire harness or connector damaged
assembly power
 ABS control module assembly
supply is
malfunctioning.
2. ABS control module
assembly is
damaged.
25 - BRAKE CONTROL SYSTEM
Possible Cause
malfunction
OK
25
OK
67
25–