Chery T21 2014 Service Manual page 661

2. Install the oil pressure tester into the thread hole (4) of oil
pressure switch as shown in the illustration.
3. Install the oil pressure switch (2) onto the tester (1) and
connect the oil pressure switch connector.
4. Connect the oil pressure switch to the body.
5. Start engine and oil pressure warning light (3) comes on,
then observe the pressure reading on tester. If oil
pressure warning light still comes on when oil pressure is
higher than 75 kPa, replace the oil pressure switch.
Installation
1. Remove the oil and impurities on oil pressure switch and its thread hole.
2. Apply a small amount of seal gum to the threads when
installing the oil pressure switch as shown in the
illustration.
Width of a: 3 mm
3. Other installation procedures are in the reverse order of removal.
Chery Automobile Co., Ltd.
13 - SQR484F LUBRICATION SYSTEM
1
3
-
+
4
2
a
RT21130110
RT21130120
13
17
13–