Chery T21 2014 Service Manual page 517

a. Carefully install the crankshaft bearing uppe shell (1)
in the direction of arrow, and the notch of each main
bearing upper shell should be aligned with the
cylinder block. The oil passage hole (2) on crankshaft
main bearing should be aligned with the passage hole
on cylinder block after installation.
HINT:
Install the crankshaft main bearing lower shells to the
crankshaft frame in the same way,and the notch of
each main bearing lower shell should be aligned with
the crankshaft frame.
2. Install the crankshaft thrust washer.
a. Clean the crankshaft thrust washers and cylinder block inner wall before installation.
b. Apply a coat of engine oil to the crankshaft thrust washers.
c. There are 2 crankshaft thrust washers on the cylinder, which are installed on the front and rear sides of
thrust surface (both sides of 3rd bearing) respectively.
d. As shown in the illustration, the two grooves on one
side of crankshaft thrust washers (1) face outward
while the other side without groove is jointed with the
cylinder block inside wall.
3. Install the crankshaft.
a. Apply seal gum to the installation surface of frame
before installation.
Chery Automobile Co., Ltd.
07 - SQR484F ENGINE MECHANICAL
1
2
RT21071200
1
RT21071010
RT21071210
07
95
07–