Chery T21 2014 Service Manual page 465

4. Measure flywheel end surface runout with the dial
indicator. If measured value exceeds the limit, replace the
flywheel with a new one.
Limit for end surface runout: 0.2 mm
Installation
WARNING
 Never reuse flywheel fixing bolts after removal.
 Make sure to use new flywheel fixing bolts with seal gum before installation.
CAUTION
 Six bolt holes on the flywheel have asymmetrical positions. There is a matchmark hole on flywheel. The
mark hole is located right above when 1st cylinder of engine is at the top dead center and flywheel fixing
bolts are aligned with bolt holes of crankshaft.
Installation procedures are in the reverse order of removal, and pay attention to the followings:
1. Align the flywheel installation hole with the crankshaft positioning journal and then push lightly during
assembly. Do not tap the flywheel with a hammer.
2. Replace the flywheel fixing bolts with precoated seal gum with new ones.
3. Install the flywheel fixing bolts (arrow), and then hold the
flywheel securely with the flywheel holding tool (1).
Tighten the flywheel fixing bolts.
(Tightening torque: 1st step: tighten to 35 ± 5 N·m; 2nd
step: retighten by 45° ± 5°)
Chery Automobile Co., Ltd.
07 - SQR484F ENGINE MECHANICAL
RT21070291
1
RT21070290
07
43
07–