c. Install the ball pin separator (1), and tighten the ball
pin separator bolt with a wrench (2) to separate the
steering tie rod ball pin from the steering knuckle
assembly.
d. Remove the lock pin (arrow) and coupling nut (1)
between front left control arm assembly ball pin and
front left steering knuckle assembly.
(Tightening torque: 120 ± 12 N·m)
e. Remove 2 coupling bolts and nuts (arrow) between
front left shock absorber assembly and front left
steering knuckle assembly.
(Tightening torque: 180 ± 10 N·m)
f. Detach the left drive shaft and remove the front left steering knuckle assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Always tighten coupling bolts and nuts to the specified torque.
Check and adjust front wheel alignment after installation.
Chery Automobile Co., Ltd.
22 - AXLE
2
1
RT21220130
1
RT21220140
RT21220150
13
22–
22