g. Remove the coupling bolt (1) and coupling nuts (2)
between right mounting cushion assembly and right
mounting bracket.
(Tightening torque: 80 ± 6 N·m)
h. Remove 3 coupling bolts (arrow) between right
mounting cushion assembly and body.
(Tightening torque: 70 ± 5 N·m)
i. Lower the engine assembly and remove 2 fixing bolts
(arrow) between compressor assembly and mounting
bracket.
(Tightening torque: 40 ± 5 N·m)
j. Carefully remove the compressor assembly from below.
Installation
Installation is in the reverse order of removal.
CAUTION
Tighten the fixing bolts to specified torque.
It is necessary to replace the refrigerant line O-ring when installing the refrigerant line. Failure to do so
may result in refrigerant leaks.
Lubricate the new rubber O-ring with clean refrigerant oil and install it to the refrigerant line joint.
Only use the specified O-ring, as it is made of special materials for R134a system.
Only use recommended refrigerant oil which is applicable to the A/C compressor assembly on vehicle.
When installing a new compressor assembly, always remove a certain amount of refrigerant oil from the
new A/C compressor assembly as specified.
Perform recharging for the A/C system and check refrigerant for leakage.
Chery Automobile Co., Ltd.
31 - AIR CONDITIONING
1
RT21070690
1
RT21310870
101
31–
31