Chery T21 2014 Service Manual page 1295

Steering Gear Assembly
WARNING
 Be sure to wear necessary safety equipment to prevent accidents when servicing.
 When removing and installing high temperature components and surrounding components, wait and
operate them until they drops to the normal temperature to avoid being burned.
 Prevent skin and eyes from contacting with steering fluid when removing the steering system.
CAUTION
 After disconnecting steering system line, seal it immediately to prevent foreign matter from entering.
 Never run power steering pump assembly when steering fluid is insufficient.
 Steering wheel should not be in limit positions for more than 5 seconds.
 Never start engine with hose loosened or disconnected.
 Never allow hose to contact with high temperature exhaust manifold or catalyst.
Removal
1. Set steering wheel to straight-ahead position.
2. Turn off all the electrical equipment and ignition switch.
3. Disconnect the negative battery cable.
4. Drain the steering fluid
5. Remove the front wheel
6. Remove the coupling bolt between steering column with
intermediate shaft assembly and input shaft of steering
gear.
(Tightening torque: 30 ± 3 N·m)
7. Separate the ball pin assembly and steering knuckle.
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
Chery Automobile Co., Ltd.
(See page 29-7).
(See page 24-9).
29 - HYDRAULIC ASSIST STEERING
RT21280180
29–
29
23