Chery T21 2014 Service Manual page 749

2. Check starter solenoid switch.
a. Check pull-in coil.
 Measure resistance between terminal 50 and
terminal C.
 Standard resistance should be below 2 Ω.
If result is not as specified, replace the starter.
b. Check hold-in coil.
 Measure resistance between terminal 50 and
starter solenoid switch body.
 Standard resistance should be below 2 Ω.
If result is not as specified, replace the starter.
3. Check starter assembly.
CAUTION
 These tests must be performed within 3 to 5 seconds to avoid burning out coil.
 Secure the starter assembly in a vise. Jaws of the vise should be covered by aluminum plate or brass
plate; otherwise the starter assembly will be easily damaged when clamping it.
a. Perform pull-in test.
 Remove the nut, and disconnect the field coil lead
from terminal C.
 As shown in the illustration, connect battery to the
solenoid switch, and check that the starter clutch
pinion extends.
If the starter clutch pinion does not move, replace the starter assembly.
Chery Automobile Co., Ltd.
15 - SQR484F STARTING SYSTEM
Terminal 50
Terminal C
Terminal 50
Switch Body
Terminal 50
Terminal C
-
+
RT21150080
RT21150090
15
Body
RT21150100
65
15–