8.8.2 Software
TNC settings
8 – 44
The TNC requires an NFS server (Network File System) as the remote station.
The NFS server must work according to the TCP/IP protocol principle. The
remote station must be an NFS server.
OSI 7-layer model
7
Application layer
6
Presentation layer
5
Communications layer
4
Transport layer
3
Network layer
2
Data link layer
1
Physical layer
Before networking, the TNC must be properly configured. Please discuss the
required settings with your network supervisor.
7 7 7 7
Press the MOD key in the Programming and Editing operating mode and
enter the code number NET123. With the soft keys you can select the
required network options:
Soft key
Option
Settings on the TNC for networking
ADDRESS
MASK
ROUTER
PROT
HW
Meaning
Internet address of the TNC: Enter as four
decimal numbers separated by points (dotted-
decimal notation). Your network supervisor can
give you an internet address.
Subnet mask: Enter as four decimal numbers
separated by points (dotted-decimal notation).
Internet address of default router: Enter as four
decimal numbers separated by points (dotted-
decimal notation). This entry is required only if
your network consists of several subnetworks
interconnected by router.
Protocol (RFC/IEEE): You can choose one of two
transmission protocols for the Ethernet interface:
RFC 894 or IEEE 802.2/802.3.
Connection (10 BaseT/ 10Base2): Here you
define which of the two ports you wish to use for
your network.
HEIDENHAIN Technical Manual TNC 426, TNC 430
TNC
NFS
TCP protocol
IP protocol
Ethernet card