Debug Ip Dhcp Server; Default-Router - Dell Force10 S4810P Reference Manual

Usage Entering <CR> after the clear ip dhcp binding command clears all the IPs from the
Information binding table.

debug ip dhcp server

Display FTOS debugging messages for DHCP.
C-Series, S-Series, Z-Series
Syntax debug ip dhcp server [events | packets]
Parameters
events
packet
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.2.1.0

default-router

Assign a default gateway to clients based on the address pool.
C-Series, S-Series, Z-Series, S4810
Syntax default-router address [address2...address8]
Parameters
address
Defaults none
Command Modes DHCP <POOL>
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
654
Enter the keyword events to display the DHCP state changes.
Enter the keyword packet to display packet transmission/reception.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Enter a list of routers that may be the default gateway for clients on
the subnet. You may specify up to eight routers. List them in order of
preference.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.