Autopvc Config - THOMSON ST780 WL Cli Reference Manual

autopvc config

Configure autopvc.
SYNTAX:
autopvc config
where:
mode Select the autopvc mode:
>
pseudo: only pseudo-ILMI (VP/VC 15/16) is enabled. When the
connection parameters are written to the MIB, this information is
displayed on CLI or web interface but these parameters are not used
for configuration.
>
passive: both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16) are
enabled. When the connection parameters are written to the MIB, this
information is displayed on CLI or web interface but these parameters
are not used for configuration.
>
active: both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16) are
enabled. When the connection parameters are written to the MIB,
these parameters are used to configure phonebook entries, qosbook
profiles and bind bridge or PPPoE interfaces on top.
The default is passive.
type Select the type of autopvc.
Choose between:
>
bridge
>
pppoerelay: an ETHoA interface will be created, will be bound to the
ILMI Permanent Virtual Channel (PVC) and will be added to the PPPoE
relay as relay port.
>
ipoa
>
ethoa
>
pppoa
>
pppoe.
overwrit Enable or disable UBR peak rate overwrite.
e The default is disabled.
peakrate A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).
The default is
70
[mode = <{pseudo | passive | active}>]
[type = <{bridge | pppoerelay | ipoa | ethoa | pppoa | pppoe
}>]
[overwrite = <{disabled | enabled}>]
[peakrate = <number{0-27786}>]
0 (indicates the linerate).
AutoPVC Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0