Nat Commands - THOMSON ST780 WL Cli Reference Manual

NAT Commands

29 NAT Commands
Introduction
This chapter describes the commands of the nat command group.
Contents
This chapter covers the following commands:
nat config
nat flush
nat ifconfig
nat iflist
nat mapadd
nat mapdelete
nat maplist
nat tmpladd
nat tmpldelete
nat tmpllist
nat tmplinst
E-DOC-CTC-20061027-0012 v2.0
Display/modify global NAT configuration options.
Flush the current NAT configuration.
Modify address translation on an IP interface.
Display the address translation configuration on all the interfaces.
Add an address mapping to a Network Address Translation (NAT)
enabled interface.
Delete an address mapping from a NAT enabled interface.
Display the address mapping for a NAT enabled interface.
Add an address mapping template.
Delete an address mapping template.
Display the address mapping templates.
Instantiate address mapping templates for a given dynamic address.
568
569
570
571
572
576
577
578
582
583
584
567