Firewall Config - THOMSON ST780 WL Cli Reference Manual

firewall config

Configure the firewall options.
SYNTAX:
firewall config
where:
state
keep
tcpchecks
udpchecks
icmpchecks
346
[state = <{disabled | enabled}>]
[keep = <{disabled | enabled}>]
[tcpchecks = <{none | fast | exact}>]
[udpchecks = <{disabled|enabled}>]
[icmpchecks = <{disabled | enabled}>]
[logdefault = <{disabled | enabled}>]
[logthreshold = <{disabled | enabled}>]
[tcpwindow = <number{0-1073725440}>]
Enable or disable the firewall.
The default is enabled.
The firewall keeps active connections (enabled) or not
(disabled) when the firewall rules change.
The default is disabled.
Select the level of TCP sequence number checks. Choose
between:
>
none: no TCP checks are done.
>
fast: check all the combinations of flag and disallow all the
possible illegal combinations shown below:
SYN PSH (SYN PSH URG,...)
SYN FIN (SYN FIN PSH, SYN FIN RST PSH,...)
FIN flag set without ACK
All flags set
No flags set.
>
exact: check and permit only combinations of flag with the
TCP state of a connection:
SYN: request to open connection
SYN ACK: agree to open connection
A, PA, AU, PAU: acknowledgement of receipt
FA, FAP, FAU, FAP, FAPU, FAU, FPAU: request to close
connection
R, RA, RP, RU, RPA, RPU, RAU, RPAU: tear down
connection.
The default is none.
Disable or enable keeping UDP checks.
The default is enabled.
Disable or enable keeping ICMP checks.
The default is enabled.
Firewall Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0