Ppp Commands - THOMSON ST780 WL Cli Reference Manual

PPP Commands

30 PPP Commands
Introduction
This chapter describes the commands of the ppp command group.
Contents
This chapter covers the following commands:
ppp flush
ppp ifadd
ppp ifattach
ppp ifconfig
ppp ifdelete
ppp ifdetach
ppp iflist
ppp ifscan
ppp rtadd
ppp rtdelete
ppp relay flush
ppp relay ifadd
ppp relay ifconfig
ppp relay ifdelete
ppp relay iflist
ppp relay sesslist
E-DOC-CTC-20061027-0012 v2.0
Flush all PPP interfaces.
Create a new PPP interface.
Attach a PPP interface.
Configure a PPP interface.
Delete a PPP interface.
Detach a PPP interface.
Display the PPP interfaces.
Scan a PPPoE interface for available Access Concentrator and
Service names.
Add a route to the routing table when the PPP link comes up.
Delete the route for a PPP link.
Remove all Ethernet interfaces from the PPP relay agent list and
terminate all sessions.
Add an Ethernet interface to the PPP relay list.
Modify an ethernet interface from the PPP relay agent list.
Delete an Ethernet interface from the PPP relay agent list.
Display all Ethernet interfaces added to the PPP relay agent list.
Add an Ethernet interface to the PPP relay list.
586
587
589
591
596
598
600
601
602
604
606
607
608
609
610
611
585