Grp Rip Ifconfig - THOMSON ST780 WL Cli Reference Manual

GRP Commands

grp rip ifconfig

Configure a RIP interface.
SYNTAX:
grp rip ifconfig
where:
intf
rip
rxversion
authmode
authstring
splithorizon
E-DOC-CTC-20061027-0012 v2.0
intf = <string>
[rip = <{disabled | enabled}>]
[rxversion = <{rip_unspec | rip_v1 | rip_v2 | rip_v1-2}>]
[authmode = <{none | cleartext}>]
[authstring = <quoted string>]
[splithorizon = <{disable | enable}>]
The name of the RIP interface to be configured.
Use the command :grp iflist to obtain a list of avail-
Tip
able interfaces.
Enabled or disabled RIP on this interface.
The default is disabled.
Configure the RIP receive version to be applied.
Choose between:
>
rip_unspec: No RIP version is specified as such. The actual RIP
version to be used is negotiated with the remote side.
>
rip_v1: RIP version 1 is used.
>
rip_v2: RIP version 2 is used.
>
rip_v1-2: RIP version 1 and RIP version 2 are used.
The default is rip_unspec.
Configure the RIP authentication mode.
Enter the mode in cleartext or specify none in case no authentication
mode is required.
The default is none.
Configure the authentication string for the RIP authentication
password.
Note Leave authstring unspecified in case
Enable or disable the split horizon status for this interface.
The default is enabled.
authmode is none.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
385