Pptp Ifadd - THOMSON ST780 WL Cli Reference Manual

pptp ifadd

Add a Point-to-Point Tunneling Protocol (PPTP) profile.
i
Backwards compatible with previous release, use profiles instead.
SYNTAX:
pptp ifadd
where:
dest
rate
encaps
ac
614
dest = <string>
[rate = <number{10-10000}>]
[encaps = <{vcmux | nlpid}>]
[ac = <{never | always | keep}>]
The WAN destination for this PPTP tunnel.
Typically a phonebook entry.
A number between 10 and 10000.
Represents the transmission speed (in bits/s) for the WAN link.
The type of WAN encapsulation to be used with this PPTP profile.
Choose between:
>
VC_MUX
>
Network Layer Protocol IDentifiers (NLPID).
The default is vcmux.
The High-level Data Link Control (HDLC) framing option applicable
to PPTP interfaces using this PPTP profile.
Choose between:
>
always: Before relaying the encapsulated PPP frames over the
PPPoA link, make sure that the address and control field
(0xFF03) is always in front of the frames.
>
never: Before relaying the encapsulated PPP frames over the
PPPoA link, make sure the address and control field will never
be found in front of the frames.
>
keep: Do not change the frames arriving via the PPTP tunnel.
The default is never.
Note The default setting is compliant to RFC2364, therefore it is
recommended to keep this setting.
PPTP Commands
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0