Nat Ifconfig - THOMSON ST780 WL Cli Reference Manual

nat ifconfig

Modify address translation on an IP interface.
SYNTAX:
nat ifconfig
where:
intf
translation
EXAMPLE:
=>nat iflist
Interface NAT
loop disabled
myPPP_ppp disabled
eth0 transparent
=>nat ifconfig intf=myPPP_ppp translation=enabled
=>nat iflist
Interface NAT
loop disabled
myPPP_ppp enabled
eth0 transparent
=>
RELATED COMMANDS:
nat iflist
570
intf = <string>
translation = <{disabled | enabled | trans-
parent}>
The IP interface name.
Enable or disable address translation.
Choose between:
>
disabled: Address translation is disabled.
>
enabled: Address translation is enabled.
>
transparent: An inside address is translated into the same
outside IP address. In fact, no translation happens and the
IP packets passing through the Thomson ST remain
untouched.
The default is disabled.
Display the address translation configuration on all the interfaces.
NAT Commands
REQUIRED
REQUIRED
E-DOC-CTC-20061027-0012 v2.0