Eth Switch Shaper Ifconfig - THOMSON ST780 WL Cli Reference Manual

Eth Commands

eth switch shaper ifconfig

Configure per port shaper parameters.
SYNTAX:
eth switch shaper ifconfig
where:
port
ingress
shaper
state
speed
burstsize
RELATED COMMANDS:
eth switch shaper config
eth switch shaper iflist
E-DOC-CTC-20061027-0012 v2.0
port = <number{1-4}>
ingress = <disabled|enabled>
shaper = <number{0-1}>
[state = <disabled|enabled>]
[speed = <number{64000-100000000}>]
[burstsize = <number{6-126}>]
Port number
Enabled: port is ingress port
Disabled: port is egress port
Shaper instance
Enable/disable shaping
Speed in bits/sec.
Burst size in KBytes
Configure common ingress shaper parameters.
Display shaper configuration per port.
REQUIRED
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
321