Ipqos Config - THOMSON ST780 WL Cli Reference Manual

ipqos config

Configure IPQoS for a given destination interface for the IPQoS queues instantiation.
i
When enabling or disabling IPQoS, take the following into account:
>
if the WAN interface (for example PPPoA, IP oA,...) is detached at the time of enabling/disabling
IPQoS, then the WAN interface has to be attached in order for the enabling/disabling of IPQoS to
take effect.
>
if the WAN interface is attached at the time of enabling/disabling IPQoS, then the WAN interface
has to be detached and then re-attached in order for the enabling/disabling of IPQoS to take
effect.
SYNTAX:
ipqos config
where:
dest
state
discard
476
dest = <string>
[state = <{disabled | enabled}>]
[discard = <{tail | early}>]
[priority = <{wfq | strict | wrr}>]
[realtimerate = <number{1-100}>]
[burstsize = <number{1-128}>]
[weight1 = <number{1-97}>]
[weight2 = <number{1-97}>]
[weight3 = <number{1-97}>]
[weight4 = <number{1-97}>]
[maxpackets = <number{0-100}>]
[maxbytes = <number{0-128}>]
The destination interface for the IPQoS queues instantiation.
This is an ATM phonebook entry.
Disable or enable IPQoS for the interface.
The default is disabled.
Determines the packet discard strategy in case of congestion.
Choose between:
>
tail: Tail Drop: arriving packets will be dropped as soon as the
destination queue is in an overflow state.
>
early: Early Packet discard: arriving packets will be dropped early
according to the BLUE active queue management algorithm.
The default is early.
IPQoS Commands
REQUIRED
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0