Connection Commands - THOMSON ST780 WL Cli Reference Manual

Connection Commands

6 Connection Commands
Introduction
This chapter describes the commands of the connection command group.
Contents
This chapter covers the following commands:
connection appconfig
connection appinfo
connection applist
connection bind
connection bindlist
connection clean
connection clear
connection config
connection debug
connection describe
connection flush
connection info
connection list
connection refresh
connection stats
connection timerclear
connection timerconfig
connection unbind
E-DOC-CTC-20061027-0012 v2.0
Configure the available CONN/NAT application helpers.
Display CONN/NAT application specific info.
List the available CONN/NAT application helpers.
Create a new CONN/NAT application helper/port binding.
List the current CONN/NAT application helper/port bindings.
Clean the connection database by forcing timeouts.
Kill all the connections.
Configure the connection handling.
The connection debug commands
Describe the streams of a connection.
Flush the current connection configuration.
Show all the registered modules with some info.
Display the currently known connections.
Invalidate all the cached decisions.
Display the connection and stream statistics.
Clear the connection timeout to default.
Configure the connection timeout handling.
Delete an existing CONN/NAT application helper/port binding.
82
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
81