Wireless Commands - THOMSON ST780 WL Cli Reference Manual

Wireless Commands

44 Wireless Commands
Introduction
This chapter describes the commands of the wireless command group.
Contents
This chapter covers the following commands:
wireless ifconfig
wireless reset
wireless debug stats
wireless debug txpower
wireless macacl add
wireless macacl config
wireless macacl delete
wireless macacl flush
wireless macacl list
wireless macacl modify
wireless macacl register
wireless multiuni add
wireless multiuni delete
wireless multiuni flush
wireless multiuni list
wireless multiuni
scanresults
wireless qos config
wireless qos apacconfig
wireless qos staacconfig
wireless secmode config
wireless secmode wep
wireless secmode wpa-
psk
wireless secmode wpa
wireless stations list
wireless wds add
wireless wds config
wireless wds delete
wireless wds flush
wireless wds list
wireless wds scanresults
E-DOC-CTC-20061027-0012 v2.0
Configure the wireless settings.
Reset the wireless parameters.
Show the transfer statistics.
Tx power override.
Add an ACL MAC entry.
Configure the ACL mode.
Delete an ACL MAC entry.
Flush ACL entries.
Show a list of all configured ACL entries.
Modify an existing ACL entry.
Start a registration process (only for register mode).
Add a multicast to unicast mapping.
Delete all multicast mappings.
Flush all multicast to unicast mappings.
Show configured multicast to unicast mappings.
Display detected multicast mac addresses.
Configure QoS settings.
Configure AP EDCA parameters.
Configure STA EDCA parameters.
Configure/show the security mode.
Configure the WEP settings.
Configure the WPA-PSK settings.
Configure the WPA settings.
List the currently associated stations.
Add a Wireless Distribution System (WDS) station.
WDS configuration parameters.
Delete a WDS station.
Flush all WDS stations.
List the WDS stations.
Scan all networks.
809
811
813
814
815
816
817
818
819
820
821
822
823
824
825
826
827
828
829
830
831
832
833
834
835
836
837
838
839
840
807