Systemlog Show - THOMSON ST780 WL Cli Reference Manual

Systemlog Commands

systemlog show

Show messages in the internal Syslog message buffer.
SYNTAX:
systemlog show
where:
fac
sev
hist
E-DOC-CTC-20061027-0012 v2.0
[fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{disabled | enabled}>]
Specify the facility name of the syslog messages to be shown.
Use one of the supported facility names (see
on page 867).
Note If not specified, the messages of all the facilities will be
shown.
Specify the lowest priority severity of the syslog messages to be
shown.
All the syslog messages with severity as specified or higher will be
shown.
Use one of the supported severity names (see
Severities" on page 868).
Note If not specified, the messages of all the severities will be
shown.
Show messages over several Thomson ST reboots (enabled) or show
only messages since latest startup (disabled).
Note If not specified, only the recent messages will be shown.
" Supported Facilities"
" Supported
OPTIONAL
OPTIONAL
OPTIONAL
743