Ip Ifconfig - THOMSON ST780 WL Cli Reference Manual

IP Commands

ip ifconfig

Configure the parameters of an IP interface.
SYNTAX:
ip ifconfig
where:
intf
mtu
status
hwaddr
group
linksensing
primary
mcastpromisc
E-DOC-CTC-20061027-0012 v2.0
intf = <string>
[mtu = <number{68-65535}>]
[status = <{down | up}>]
[hwaddr = <hardware-address>]
[group = <string> or number]
[linksensing = <{disabled | enabled}>]
[primary = <{disabled | enabled}>]
[mcastpromisc = <{disabled|enabled}>]
The name of the IP interface to be configured.
A number between 68 and 65535.
Represents the MTU (the maximum packet size (including IP
header)) to be used on this interface.
Note The default value depends on the connection and packet
service for which the interface was created.
The administrative state of the interface.
Choose between:
>
down
>
up.
The hardware address (for example the Ethernet MAC address) of
this IP interface.
The group to which this interface belongs. Can be used for
firewalling, for example.
The IP interface's awareness of link state transitions.
The default is enabled.
Make the IP interface the primary interface (enabled) or not
(disabled).
The default is disabled.
Make the IP interface multicast promiscuous.
Choose between:
>
disabled
>
enabled
The default is disabled.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
443