Atm Bundle Ifconfig - THOMSON ST780 WL Cli Reference Manual

ATM Commands

atm bundle ifconfig

Configure an interface from a bundle.
The interface to be configured must not be connected at the time of configuration. If this should be
i
the case, use the command :atm bundle ifdetach before using the command :atm bundle
ifconfig.
SYNTAX:
atm bundle ifconfig
where:
name
intf
state
low
high
E-DOC-CTC-20061027-0012 v2.0
name = <string>
intf = <string>
[state = <{disabled | enabled}>]
[low = <number{0-15}>]
[high = <number{0-15}>]
The name of the bundle from which an ATM interface must be configured.
The name of the ATM interface to be configured.
Enable or disable the ATM interface.
The default is enabled.
A number between 0 and 15.
Represents the low selector value.
Note This parameter must only be configured when the policy of the
bundle is set to priority
A number between 0 and 15.
Represents the high selector value.
Note This parameter must only be configured when the policy of the
bundle is set to priority
(see " atm bundle config" on page
(see " atm bundle config" on page
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
29).
OPTIONAL
29).
35