Snmp Commands - THOMSON ST780 WL Cli Reference Manual

SNMP Commands

35 SNMP Commands
Introduction
This chapter describes the commands of the snmp command group.
Contents
This chapter covers the following commands:
snmp config
snmp get
snmp getnext
snmp walk
snmp community add
snmp community delete
snmp community list
snmp community modify
snmp ifadd
snmp ifdelete
snmp ifattach
snmp ifdetach
snmp ifconfig
snmp iflist
E-DOC-CTC-20061027-0012 v2.0
Show/set global Simple Network Management
Protocol (SNMP) parameters.
Get from the supplied SNMP Object IDentifier (OID).
GetNext from the supplied SNMP OID.
Walk from the supplied SNMP OID.
Configure an SNMP community string to allow SNMP access
over IP.
Delete an SNMP community string to prevent SNMP access
over IP.
List all SNMP community strings in use for SNMP access over
IP.
Modify an SNMP community string to allow SNMP access over
IP.
Create a new SNMP interface.
Delete an SNMP interface.
Attach an SNMP interface.
Detach an SNMP interface.
Modify an SNMP interface.
Display the SNMP interfaces.
700
701
702
703
704
705
706
707
708
709
710
711
712
713
699