Wireless Ifconfig - THOMSON ST780 WL Cli Reference Manual

Wireless Commands

wireless ifconfig

Configure the wireless settings.
SYNTAX:
wireless ifconfig
where:
state
channel
ssid
any
interop
frameburst
E-DOC-CTC-20061027-0012 v2.0
[state = <{enabled | disabled}>]
[channel =
<{auto | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10
[ssid = <quoted string>]
[any = <{disabled | enabled}>]
[interop = <{802.11b | 802.11b/g | 802.11g}>]
[frameburst = <{disabled | enabled}>]
Enable or disable the interface operational status of wireless access
point.
The default is enabled.
The communication channel number.
Choose between:
>
auto: the best communication channel is automatically selected by
the Thomson ST (recommended setting).
>
a number between 1 and 14.
Note Depending on local regulations, the number of channels
actually allowed to be used, may be restricted.
The default is auto.
The network name, also known as Service Set ID (SSID).
Make the SSID public or not.
Choose between:
>
enabled: the Thomson ST broadcasts its SSID and accepts every
client.
>
disabled: the Thomson ST does not broadcast its SSID and accepts
only those clients who have the correct SSID.
The default is enabled.
Select the interoperability mode.
Choose between:
>
802.11b: only IEEE 802.11b clients can connect to the Thomson ST.
>
802.11b/g: IEEE 802.11g and b clients can connect to the Thomson
ST.
Note When a IEEE 802.11b client connects to the Thomson ST,
the modulation rate drops to 11Mbps for this client.
>
802.11g: only IEEE 802.11g clients can connect to the Thomson ST.
The default is 802.11b/g.
Enable or disable framebursting.
The default is disabled.
| 11 | 12 | 13}>]
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
809