Nat Tmpladd - THOMSON ST780 WL Cli Reference Manual

nat tmpladd

Add an address mapping template.
SYNTAX:
nat tmpladd
where:
intf
group
timeout
type
578
[intf = <string>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[timeout = <number{0-65535}>]
[type = <{napt | nat}>]
outside_addr = <ip-range>
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{supported IP protocol} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto | inbound | outbound}>]
The IP interface name.
The IP interface group scope for this template.
Choose between:
>
wan
>
local
>
lan
>
tunnel
>
dmz
>
guest.
Note If an interface has been defined with the parameter intf,
then the setting for this parameter is ignored.
A number between 0 and 6553 (seconds).
Represents the lifetime for this template.
The type of NAT map to be used.
Choose between:
>
napt: The map is a NAPT map or a port-shifting NAT map.
>
nat: The map is a basic NAT map or a two-way NAT map.
NAT Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0