Cwmp Config - THOMSON ST780 WL Cli Reference Manual

cwmp config

Configure the cwmpd as seen from the ACS.
SYNTAX:
cwmp config
where:
state
mode
periodicInform
periodicInfInt
sessionTimeout
noIpTimeout
102
[state = <{disabled|enabled}>]
[mode = <{readonly|full}>]
[periodicInform = <{disabled|enabled}>]
[periodicInfInt = <number>]
[sessionTimeout = <number>]
[noIpTimeout = <number>]
[maxEnvelopes = <number>]
[connectionRequest = <{disabled|enabled}>]
[connectionReqPath = <string>]
[connectionReqUserName = <string>]
[connectionReqPsswd = <string>]
[connectionReqAuth = <{none|basic|digest}>]
[qos-class = <number>]
[bootdelayrange = <number>]
The state of the cwmp daemon.
Choose between:
>
enabled
>
disabled.
The default is disabled.
Set the operation mode of the cwmp daemon.
Choose between:
>
readonly
>
full.
The default is readonly.
Set the periodicInform flag of the cwmp daemon.
Choose between:
>
enabled
>
disabled.
The default is enabled.
A number (of seconds).
Represents the interval between two periodicInform
messages.
The default is 3600.
Set HTTP session-timeout in seconds.
The default is 60.
Set time (in seconds) ip may be 0 after uploading new
config file.
The default is 10.
CWMP Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0