Eth Device Ifconfig - THOMSON ST780 WL Cli Reference Manual

Eth Commands

eth device ifconfig

Configure an Ethernet interface.
SYNTAX:
eth device ifconfig
where:
intf
type
state
E-DOC-CTC-20061027-0012 v2.0
intf = <string>
[type = <{auto | 10BaseTHD | 10BaseTFD |
100BaseTHD| 100BaseTFD} or number>]
[state = <{enabled | disabled}>]
The name of a physical interface.
The Ethernet type.
Select either:
>
auto: Auto negotiation of Ethernet communication speed
(10Mb/s or 100Mb/s) and Duplex mode (half duplex or full
duplex).
>
10BaseTHD: 10Mb/s communication speed in half duplex
mode.
>
10BaseTFD: 10Mb/s communication speed in full duplex
mode.
>
100BaseTHD: 100Mb/s communication speed in half duplex
mode.
>
100BaseTFD: 100Mb/s communication speed in full duplex
mode.
or enter a number between 0 (auto) and 5 (100BaseTFD).
The default is auto.
Note This value should never be changed, except in case of
communication problems.
Enable or disable the interface.
The default is enabled.
REQUIRED
OPTIONAL
OPTIONAL
303