Dhcp Server Pool Config - THOMSON ST780 WL Cli Reference Manual

dhcp server pool config

Configure a DHCP server pool.
SYNTAX:
dhcp server pool config
where:
name
intf
index
poolstart
poolend
netmask
172
name = <string>
intf = <string>
[index = <number>]
[poolstart = <ip-address>]
[poolend = <ip-address>]
[netmask = <ip-mask(dotted or cidr)>]
[gateway = <ipaddress | 0>]
[server = <ipaddress | 0>]
[primdns = <ipaddress | 0>]
[secdns = <ipaddress | 0>]
[dnsmetric = <number{0-100}>]
[primwins = <ipaddress | 0>]
[secwins = <ipaddress | 0>]
[leasetime = <number>]
[unnumbered = <{disabled | enabled}>]
[localgw = <{disabled | enabled}>]
The name of the DHCP server pool to configure.
The interface for which the pool is allowed to lease IP
addresses.
A number between 0 (highest priority) and the highest number
(lowest priority) found in the list of existing DHCP server pools.
Represents a (higher) priority for the DHCP server pool.
Use the command :dhcp server pool list to
Tip
obtain a list of the index numbers of all current
DHCP server pools.
The lowest IP address in the DHCP address range to use for
leasing.
The default value of this parameter is 0.0.0.0 (not specified),
which means that the lowest IP address of the pool will be
defined by the remote server via Internet Protocol Control
Protocol (IPCP) as soon as the Point-to-Point Protocol (PPP)
IPCP subnetmasking connection is established.
The highest IP address in the DHCP address range to use for
leasing.
The default value of this parameter is 0.0.0.0 (not specified),
which means that the highest IP address of the pool will be
defined by the remote server via IPCP as soon as the PPP IPCP
subnetmasking connection is established.
The applicable netmask for the DHCP leases.
DHCP Commands
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0