System Rtc Settime - THOMSON ST780 WL Cli Reference Manual

System Commands

system rtc settime

Set/get date, time, timezone, daylight savings time, uptime.
When synchronization with an external NTP server via the Thomson ST SNTP client fails, this command
allows to manually configure its internal clock.
i
In cases without regular synchronization, accurate realtime clock settings can not be guaranteed.
SYNTAX:
system rtc settime
where:
date
time
timezone
daylightsaving
EXAMPLE:
=>system settime
date = 31/01/2005
time = 18:05:16
timezone = +00:00
daylightsaving = off
=>
E-DOC-CTC-20061027-0012 v2.0
[date = <dd/mm/yyyy>]
[time = <hh:mm:ss>]
[timezone = <(+ or -)hh:mm>]
[daylightsaving = <{disabled | enabled}>]
The system date formatted as dd/mm/yyyy.
Note If not specified, the current date is preserved.
The system time formatted as hh:mm:ss.
Note If not specified, the current time is preserved.
The system timezone formatted as (+ or -)hh:mm.
Valid timezones are possible from -12:00 to +14:00 with a resolution
of 15 minutes.
Note If not specified, the current timezone is preserved.
Enable or disable daylight saving.
The default is disabled.
Note If not specified, the current daylight saving setting is
preserved.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
739