Rip Module - THOMSON ST780 WL Cli Reference Manual

Hide thumbs Also See for ST780 WL:

Table of Contents

System Logging Messages

RIP Module

E-DOC-CTC-20061027-0012 v2.0

RIP Packet received from unknown interface

RIP Packet size is smaller than minimum size

RIP Packet size is greater than maximum size

RIP Wrong RIP packet alignment

RIP RIP version 0 with command <command-name> received

RIP Reserved field not zero in RIP header

RIP RIP is not enabled for network address <ip-address>

RIP Packet's v<version_nr> does not match to RIP v<version_nr>

RIP Packet's v<version_nr> does not match to RIP v<version_nr> on interface

RIP Packet v<version_nr> is dropped because authentication is disabled on

interface <intf-name>

RIP Simple password authentication failed on interface<intf-name>

RIP No authentication in RIP packet

RIP Obsolete command <command-name> received

RIP Unknown RIP command received

RIP Response does not come from default RIP port

RIP Datagram doesn't come from a valid neighbor: <ip-address>

RIP Unsupported family from <ip-address>

RIP Network is net 127, class D or class E network

RIP Address <ip-address> is my own address, net 0 or not unicast

RIP RIPv1 packet with incorrect must be zero fields

RIP Route metric is not in the 1-16 range

RIP Nexthop address is not directly reachable <ip-address>

RIP RIPv2 address <ip-address> is not correct mask /<mask> applied

RIP Not configured for sending RIPv1 packet on interface <intf-name>

RIP RIP routing table is full

RIP Neighbor <ip-address> is not connected to direct network

RIP Interface <intf-name> has not any valid local IP address for sending RIPv2

RIP Interface <intf-name> has not any valid %s address for sending

RIPv<version_nr> packets

Show Quick Links

Table of Contents