Ip Commands - THOMSON ST780 WL Cli Reference Manual

IP Commands

22 IP Commands
Introduction
This chapter describes the commands of the ip command group.
Contents
This chapter covers the following commands:
ip arpadd
ip arpdelete
ip arplist
ip config
ip flush
ip ifadd
ip ifattach
ip ifconfig
ip ifdelete
ip ifdetach
ip iflist
ip ifwait
ip ipadd
ip ipconfig
ip ipdelete
ip iplist
ip mcast rtadd
ip mcast rtdelete
ip mcast rtlist
ip mcast flush
ip rtadd
ip rtdelete
ip rtlist
ip auto flush
ip auto ifadd
ip auto ifattach
ip auto ifconfig
ip auto ifdelete
ip auto ifdetach
ip auto iflist
ip debug httpprobe
E-DOC-CTC-20061027-0012 v2.0
Add an entry to the ARP cache of a broadcast Internet Protocol
(IP) interface.
Delete an entry from the ARP cache.
Display the ARP cache.
Show/set global IP stack configuration options.
Flush all the static IP parameters.
Create an IP interface.
Attach an IP interface.
Configure the parameters of an IP interface.
Delete an IP interface.
Detach an IP interface.
Display all the IP interfaces.
Wait for a status change of an IP interface.
Assign an IP address to an IP interface.
Modify an IP address configuration.
Remove an IP address from an IP interface.
Display all the configured IP addresses.
Add a multicast route to the multicast routing table.
Delete a multicast route from the multicast routing table.
Display the multicast routing table.
Flush the multicast routing table.
Add a route to the routing table.
Delete a route from the routing table.
Display the routing table.
Flush the autoIP interfaces.
Create an autoIP interface.
Select and assign a link-local address to an autoIP interface.
Configure an autoIP interface.
Delete an existing autoIP interface.
Release the link-local address for the given autoIP interface.
Display the autoIP interfaces.
Send a HTTP probe.
435
436
437
438
440
441
442
443
445
446
447
448
449
450
451
452
453
454
455
456
457
459
460
461
462
463
464
466
467
468
469
433