Eth Bridge Ifconfig - THOMSON ST780 WL Cli Reference Manual

eth bridge ifconfig

Modify a bridge interface configuration.
SYNTAX:
eth bridge ifconfig
where:
brname
intf
dest
portstate
retry
vlan
prioconfig
276
[brname = <{bridge}>]
intf = <string>
[dest = <string>]
[portstate = <{disabled | learning |
forwarding}>]
[retry = <number{0-65535}>]
[prioconfig = <{disabled|over-
write|increase}>]
[vlan = <string>]
[ipprec = <{disabled|precedence|dscp}>]
[priority = <number{0-7}>]
[regenprio = <string>]
[ingressfiltering = <{disabled |
enabled}>]
[acceptvlanonly = <{disabled | enabled}>]
[mcastfilter = <{disabled|enabled}>]
[dynvlan = <{disabled|enabled}>]
[igmpsnooping = <{disabled|enabled}>]
The name of a bridge instance.
The name of the bridge interface to be configured.
The destination for this interface.
Typically an ATM or a physical interface name.
The bridge portstate for this interface.
Choose between:
>
disabled
>
learning
>
forwarding.
The default is forwarding.
A number between 0 and 65535.
Represents the number of times the Thomson ST retries to set
up a WAN connection before giving up.
The default is 10.
Select the default VLAN.
The priority configuration for this interface.
Eth Commands
OPTIONAL
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20061027-0012 v2.0