Siemens SINAMICS G120 Manual page 98

Parameters
List of Parameters
p0796 CU digital inputs simulation mode setpoint / CU DI simul setp
Access level: 3
Can be changed: U, T
Units group: -
Min
-
Description: Sets the setpoint for the input signals in the digital input simulation mode.
Bit field: Bit Signal name
00 DI 0 (T. 5)
01 DI 1 (T. 6)
02 DI 2 (T. 7)
03 DI 3 (T. 8)
04 DI 4 (T. 16)
05 DI 5 (T. 17)
11 DI 11 (T. 3, 4) AI 0
12 DI 12 (T. 10, 11) AI 1
Dependency: The simulation of a digital input is selected using p0795.
Refer to: p0795
Notice: To the terminal designation:
The first designation is valid for CU320, the second for CU310.
Note: This parameter is not saved when data is backed up (p0971).
AI: Analog Input
DI: Digital Input
T: Terminal
p0797[0...3] CU analog inputs simulation mode / CU AI sim_mode
Access level: 3
Can be changed: U, T
Units group: -
Min
0
Description: Sets the simulation mode for the analog inputs.
Value: 0:
1:
Index: [0] = AI0 (T. 3/4)
[1] = AI1 (T. 10/11)
[2] = AI2 (T. 50/51)
[3] = AI3 (T. 52/53)
Dependency: The setpoint for the input voltage is specified via p0798.
Refer to: p0798
Note: This parameter is not saved when data is backed up (p0971).
AI: Analog Input
1-98
No simulation mode for analog input x
Simulation mode for analog input x
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
High
High
High
High
High
High
High
High
Calculated: -
Scaling: -
Unit selection: -
Max
1
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: Unsigned32
Data set: -
Factory setting
0000 0000 0000 0000 bin
0 signal
Low
Low
Low
Low
Low
Low
Low
Low
Data type: Integer16
Data set: -
Factory setting
0
© Siemens AG 2011 All Rights Reserved
FP
-
-
-
-
-
-
-
-