Siemens SINAMICS G120 Manual page 377

Hide thumbs Also See for SINAMICS G120:
Table of Contents

Advertisement

r9999[0...99]
Software error internal supplementary diagnostics / SW_err int diag
Access level: 4
Can be changed: -
Units group: -
Min
-
Description:
Diagnostics parameter to display additional information for internal software errors.
Note:
Only for internal Siemens troubleshooting.
p11000
BI: Free tec_ctrl 0 enable / Ftec0 enab
Access level: 2
Can be changed: U, T
Units group: -
Min
-
Description:
Sets the signal source to switch in/switch out the free technology controller 0.
1 signal: The technology controller is switched in.
0 signal: The technology controller is switched out.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Parameters
List of Parameters
Data type: Unsigned32
Data set: -
Factory setting
-
Data type: U32 / Binary
Data set: -
Factory setting
0
1-377

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cu230p-2

Table of Contents