Siemens SINAMICS G120 Manual page 279

r2136[0...63] Fault time removed in days / t_flt resolv. days
Access level: 3
Can be changed: -
Units group: -
Min
-
Description: Displays the system runtime in days when the fault was removed.
Dependency: Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2133, p8401
Notice: The time comprises r2136 (days) and r2109 (milliseconds).
Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).
r2138.7...15 CO/BO: Control word faults/alarms / STW fault/alarm
Access level: 2
Can be changed: -
Units group: -
Min
-
Description: Displays the control word of the faults and alarms.
Bit field: Bit Signal name
07 Acknowledge fault
10 External alarm 1 (A07850) effective
11 External alarm 2 (A07851) effective
12 External alarm 3 (A07852) effective
13 External fault 1 (F07860) effective
14 External fault 2 (F07861) effective
15 External fault 3 (F07862) effective
Dependency: Refer to: p2103, p2104, p2105, p2106, p2107, p2108, p2112, p2116, p2117, p3110, p3111, p3112
r2139.0...12 CO/BO: Status word faults/alarms 1 / ZSW fault/alarm 1
Access level: 2
Can be changed: -
Units group: -
Min
-
Description: Displays the first status word of faults and alarms.
Bit field: Bit Signal name
00 Being acknowledged
01 Acknowledgment required
03 Fault present
06 Internal message 1 present
07 Alarm present
08 Internal message 2 present
11 Alarm class bit 0
12 Alarm class bit 1
Note: Re bit 03, 07:
These bits are set if at least one fault/alarm occurs. Data is entered into the fault/alarm buffer with delay. This is the
reason that the fault/alarm buffer should only be read if, after "fault present"/"alarm present" has occurred, a change
in the buffer was also detected (r0944, r9744, r2121).
Re bit 06, 08:
These status bits are used for internal diagnostic purposes only.
Re bit 11, 12:
These status bits are used for the classification of internal alarm classes and are intended for diagnostic purposes
only on certain automation systems with integrated SINAMICS functionality.
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
High
High
Parameters
List of Parameters
Data type: Unsigned16
Data set: -
Factory setting
-
Data type: Unsigned16
Data set: -
Factory setting
-
0 signal
No
No
No
No
No
No
No
Data type: Unsigned16
Data set: -
Factory setting
-
0 signal
No
No
No
No
No
No
Low
Low
FP
-
-
-
-
-
-
-
FP
-
-
-
-
-
-
-
-
1-279