Siemens SINAMICS G120 Manual page 136

Parameters
List of Parameters
p1056[0...n] BI: Jog bit 1 / Jog bit 1
CU230P-2 DP Access level: 3
Can be changed: T
Units group: -
Min
-
Description: Sets the signal source for jog 2.
Dependency: Refer to: p0840, p1059
Notice: The drive is enabled for jogging using BI: p1055 or BI: p1056.
The command "ON/OFF1" can be issued using BI: p0840 or using BI: p1055/p1056.
Only the signal source that was used to power up can also be used to power down again.
p1058[0...n] Jog 1 speed setpoint / Jog 1 n_set
Access level: 2
Can be changed: T
Units group: 3_1
Min
-210000.000 [rpm]
Description: Sets the speed/velocity for jog 1. Jogging is level-triggered and allows the motor to be incrementally moved.
Dependency: Refer to: p1055, p1056
p1059[0...n] Jog 2 speed setpoint / Jog 2 n_set
Access level: 2
Can be changed: T
Units group: 3_1
Min
-210000.000 [rpm]
Description: Sets the speed/velocity for jog 2. Jogging is level-triggered and allows the motor to be incrementally moved.
Dependency: Refer to: p1055, p1056
p1063[0...n] Speed limit setpoint channel / n_limit setp
Access level: 3
Can be changed: U, T
Units group: 3_1
Min
0.000 [rpm]
Description: Sets the speed limit/velocity limit effective in the setpoint channel.
Dependency: Refer to: p1082, p1083, p1085, p1086, p1088
1-136
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Data type: U32 / Binary
Data set: CDS, p0170
Factory setting
[0] 0
[1] 722.1
[2] 0
[3] 0
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
150.000 [rpm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
-150.000 [rpm]
Data type: FloatingPoint32
Data set: DDS, p0180
Factory setting
210000.000 [rpm]
© Siemens AG 2011 All Rights Reserved